http://www.bleachburnout.com/blog/2009/04/29/wilwood-hubs-arrived-for-the-tiger/ Home of the GTSparkplug Blog Sun, 21 Feb 2010 04:35:19 -0700 http://wordpress.org/?v=2.9.2 hourly 1 http://www.bleachburnout.com/blog/2009/04/29/wilwood-hubs-arrived-for-the-tiger/comment-page-1/#comment-266 Sandy Fri, 01 May 2009 00:24:39 +0000 http://gtsparkplugs.com/blog/2009/04/29/wilwood-hubs-arrived-for-the-tiger/#comment-266 In a panic last night (could be any night) I was thinking that one that was close the tie rod end to the rotor. And then a bell (warning style) went off and I had to see if the offset direction of the Wilwood rotor was not too close. It did move the rotor a bit towards the inside of the spindle but there was more room between the rotor and the tie rod end. Whew. I'm getting paranoid. Now to get the Jr. Lathe I purchased up and running and make some new spacers... In a panic last night (could be any night) I was thinking that one that was close the tie rod end to the rotor. And then a bell (warning style) went off and I had to see if the offset direction of the Wilwood rotor was not too close. It did move the rotor a bit towards the inside of the spindle but there was more room between the rotor and the tie rod end. Whew. I’m getting paranoid. Now to get the Jr. Lathe I purchased up and running and make some new spacers…

]]>